Cissell DX4 CONTROLLER Uživatelský manuál stáhnout pdf (Strana 14)

Error Codes

Page 14 of 18 FB08-15

Control Type: DX4

NOTE: If there is a gas failure the electronic ignition of the gas heated tumbler will only try to function one

time for approximately 10 seconds. If the detection device does not detect a flame, the ignition relay goes into

safe mode. When the drying cycle restarts, then the ignition will reoccur.

Table 7

Error Code Probable Cause Possible Corrective Actions

ESH The temperature sensor has

detected a temperature above

100

•

Replace temperature sensor

• Check sensor wiring

EOP The temperature sensor has

detected a temperature below 4

• Replace temperature sensor

• Check sensor wiring

VEn The exhaust air is restricted

•

Clean lint screen

• Inspect exhaust venting

rot The cylinder is not turning

• Check drive belt

• Check rotation sensor

1 2 ... 9 10 11 12 13 14 15 16 17 18

Žádné komentáře

Cissell DX4 CONTROLLER Uživatelský manuál Strana 14